ARRI SFHC-1 Instruction Manual download pdf (Page 10)

• Clean optical surfaces only with a lens brush or a clean

lens cloth! In cases of solid dirt moisten a lens cloth with

pure alcohol.

• Do not use solvents in cleaning the film gate!

• Do not remove any screws which are secured with paint!

Product Specifications

In the case of enquiries or when ordering parts, please

advise camera serial number and model.

Note: This instruction manual applies only to the

ARRIFLEX 435 Advanced.

Explanation of the Symbols

in the Instruction Manual

➪ photo indicates objects which are shown in the photo-

graphs or drawings.

Note:

This product and the accessories recommended by the

manufacturer fulfill the specifications of the EU-Guideline

89/336/EWG.

Attention:

To use the Single Frame Handcontroler (SFHC)

together with the ARRIFLEX 435 Advanced,

software version S02.00 or higher must be

installed in the camera.

The software version can be displayed on the

camera‘s left display, as described in chapter 9

(Camera Operation/ Displaying and Setting

Operational Parameters/ Overview of Display

Modes/ Mode 8 – on page 59).

To update your camera software, please contact

a ARRI service center for instructions.

If you are operating the ARRIFLEX 435 Advanced

together with the SFHC, do not modify any

parameters on the SFHC for the first three seconds

after powering up the camera (as long as the

display on the left camera side is not showing

any information). If you have modified anything

during this time period, please disconnect the

SFHC and reconnect it to reset the SFHC.

Safety Specifications

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 155 156

No comments

ARRI SFHC-1 Instruction Manual Page 10